HP Laserjet 4200 Printer

Error Codes and Support


13.01.00. JAM IN TRAY x

Error Description:

A page is jammed in tray X. A 13.01.00 error message indicates that the media did not arrive at the pre-feed sensor (PS102) within the specified time. NOTE The 13.01.00 error can also be caused by the failure of the paper-level sensor (PS107). If thi


If the actions listed above do not resolve the issue, continue with the following: 1 Open and close the specified tray while watching the control-panel display. A short delay should occur between when the tray closes and the tray-size message appears on the control-panel display. If there is no delay and you do not hear the tray-lift motor lift the tray plate into place, replace the stack position sensor (PS107, PS802, or SR2) in the tray. See Printer switches and sensors, 500-sheet feeder switches, sensors, solenoids, and PCAs, or 1,500-sheet feeder switches, sensors, solenoids, and PCAs. 2 Replace the tray X pickup solenoid. 3 Replace the tray 1 paper-pickup assembly. See Tray 1 paper-pickup assembly . 4 Replace the paper-feed assembly. See Paper-feed assembly. 5 Verify that the top-of-page sensor (PS103) is operating correctly and that the sensor flag can freely move. Replace the sensor if it is not operating correctly. See Printer switches and sensors. 6 Replace the dc controller PCA. See Dc controller PCA.

HP Laserjet 4200 DC Controller Board

MFG Part Number: RG1-4236-000CN     Condition:Refurbished    MFG:HP

This HP RG1-4236-000CN is Genuine and works with the HP 4200 Printer series. Parts are thoroughly tested, inspected for damage & defects and guaranteed 100% fully functional.


Call for Assistance 844-755-3000